2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. E155426E02
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 7 claws and remove the panel cushion.


2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

  1. B181910
    Remove the clip.

  1. Remove the screw.

  1. Detach the 8 claws.

  1. Remove the panel pad and disconnect the connectors and 2 clamps.


3. REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION

  1. B180004E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 7 claws and remove the panel cushion.


4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

  1. B180005
    Remove the clip.

  1. Remove the screw.

  1. Detach the 7 claws and remove the panel.


5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.

    B186290E01


6. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. B180006
    Detach the 7 claws.

  1. Disconnect the connectors and remove the panel.


7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180009
    Detach the 9 claws and remove the panel.


8. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

  1. B180010
    Detach the 4 claws and remove the box.


9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180011
    Detach the 14 claws.

  1. Disconnect the connectors and remove the console panel.


10. REMOVE INDOOR ELECTRICAL KEY OSCILLATOR

  1. B179746
    Disconnect the connector.

  1. Detach the 2 claws and remove the electrical key oscillator.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →