REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| 2.
REMOVE REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type) |
 |
Remove the rear No. 2 seat assembly LH (Click here).
| 3.
REMOVE REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type) |
 |
Remove the rear No. 2 seat assembly RH (Click here).
| 4.
REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type) |
 |
Remove the rear No. 2 seat assembly LH (Click here).
| 5.
REMOVE REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type) |
 |
Remove the rear No. 2 seat assembly RH (Click here).
| 6.
REMOVE REAR NO. 1 SEAT ASSEMBLY LH |
 |
Remove the rear No. 1 seat assembly LH (Click here).
| 7.
REMOVE REAR NO. 1 SEAT ASSEMBLY RH |
 |
Remove the rear No. 1 seat assembly RH (Click here).
| 8.
REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
 |
Remove the front quarter trim panel assembly LH (Click here).
| 9.
REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH |
 |
Remove the front quarter trim panel assembly LH (Click here).
| 10.
REMOVE REAR NO. 1 SEAT PROTECTOR
|
 |
Detach the 10 claws and remove the 2 seat protectors.
| 11.
REMOVE REAR NO. 2 SEAT PROTECTOR
|
 |
Detach the 10 claws and remove the 2 seat protectors.
| 12.
REMOVE INDOOR ELECTRICAL KEY OSCILLATOR |
 |
Fold back the front floor carpet assembly.
- Disconnect the connector.
Detach the 2 claws and remove the electrical key oscillator.