2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPLACEMENT

Removal / installation · Vehicles built from Jan 2012


1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove a straight pin unless it is being replaced.


A214828E03
Text in Illustration 
*1
Height
*2
Width
*3
Protrusion Height
-
-
*a
Upper Side
*b
Lower Side
*c
Front
*d
Rear
  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Straight Pin:
    Item
    Height
    Width
    Protrusion
    Pin A
    36 mm (1.42 in.)
    10 mm (0.394 in.)
    22 to 24 mm (0.866 to 0.945 in.)
    Pin B
    22 mm (0.866 in.)
    10 mm (0.394 in.)
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin C
    18 mm (0.709 in.)
    8 mm (0.315 in.)
    8.0 to 10.0 mm (0.315 to 0.394 in.)
    Pin D
    12 mm (0.472 in.)
    4 mm (0.157 in.)
    5.0 to 7.0 mm (0.197 to 0.276 in.)

← INSPECTION (from Jan 2012)REASSEMBLY (from Jan 2012) →