2011-2013 Land Cruiser · Service Manual Power Source / Network

U0132 Lost Communication with Ride Level Control Module

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

If 2 or more DTCs are output during the DTC check, one side of the CAN branch wire may be open (One side of the CANH [branch wire] /CANL [branch wire] of the ECU and/or sensor is open).
DTC Code
DTC Detection Condition
Trouble Area
U0132
There is no communication from the suspension control ECU.
  1. Power source circuit of suspension control ECU
  2. One side of CAN branch wire of other systems
  3. Suspension control ECU
  4. Suspension control ECU branch wire or connector

HINT:
For vehicles with the active height control suspension only.


WIRING DIAGRAM

C177459E02

INSPECTION PROCEDURE


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (SUSPENSION CONTROL ECU BRANCH WIRE)

  1. C150941E02
    Disconnect the K34 suspension control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    K34-7 (CANH) - K34-8 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE SUSPENSION CONTROL ECU BRANCH WIRE OR CONNECTOR (CANH, CANL)
OK


3. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the K34 and K35 suspension control ECU connectors.

  1. C177597E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    K34-1 (GND) - Body ground
    Always
    Below 1 Ω
    K35-6 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    K35-1 (BAT) - Body ground
    Always
    11 to 14 V
    K34-3 (BAT2) - Body ground
    Always
    11 to 14 V
    K34-5 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SUSPENSION CONTROL ECU (Click here)


← U0131 Lost Communication with Power Steering Control Module (from Jan 2012)U0132 Lost Communication with Ride Level Control Module (from Jan 2012) →