DATA LIST / ACTIVE TEST
System information · Vehicles built from Sep 2011
| READ DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
According to the display on the intelligent tester, read the Data List.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Communication D-Door Motor
Connection status between power window regulator motor (for driver side) and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication P-Door Motor
Connection status between power window regulator motor (for front passenger side) and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication RR-Door Motor
Connection status between power window regulator motor (for rear RH) and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication RL-Door Motor
Connection status between power window regulator motor (for rear LH) and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication Slide Roof
Connection status between sliding roof ECU and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Communication Master SW
Connection status between power window ECU (master switch) and main body ECU (cowl side junction block LH) / OK or STOP
OK: Connection
STOP: No connection
When there is a malfunction, a DTC is stored.
Number of Trouble Codes
Number of trouble codes / Min.: 0, Max.: 255
Number of DTCs will be displayed
-