2011-2013 Land Cruiser · Service Manual Power Source / Network

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Sep 2011


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Trouble Codes.

  5. Read the DTCs.


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / (desired system) / Trouble Codes.

  5. Clear the DTCs.

← TERMINALS OF ECU (from Sep 2011)DATA LIST / ACTIVE TEST (from Sep 2011) →