Display and Navigation Assembly Communication Stop Mode
Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Display and Navigation Assembly Communication Stop Mode |
|
|
- HINT:
- For vehicles with the navigation system only.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
- CAUTION:
- For vehicles with an SRS system:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
| NEXT | |
| 2. CHECK FOR OPEN IN CAN BUS WIRE (DISPLAY AND NAVIGATION MODULE DISPLAY BRANCH WIRE) |
Disconnect the F64 display and navigation module display connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
F64-21 (CANH) - F64-22 (CANL)
Ignition switch off
54 to 69 Ω
Text in Illustration *1
Front view of wire harness connector
(to Display and Navigation Module Display)
|
|
||||
| OK | |
| 3. CHECK HARNESS AND CONNECTOR (DISPLAY AND NAVIGATION MODULE DISPLAY - BATTERY AND BODY GROUND) |
Connect the cable to the negative (-) battery terminal.
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
Disconnect the F64 display and navigation module display connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F64-10 (GND1) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
F64-1 (+B1) - Body ground
Always
11 to 14 V
F64-2 (ACC) - Body ground
Ignition switch ACC
11 to 14 V
F64-3 (IG) - Body ground
Ignition switch ON
11 to 14 V
Text in Illustration *1
Front view of wire harness connector
(to Display and Navigation Module Display)
|
|
||||
| OK | ||
| ||
