2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Radio Receiver and Video Terminal

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This is the display signal circuit from the video terminal to the multi-media module receiver assembly.

WIRING DIAGRAM

E248575E01

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - VIDEO TERMINAL)
  1. Disconnect the F78 multi-media module receiver assembly connector.

  1. Disconnect the P1 headphone terminal (video terminal) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F78-6 (VV+) - P1-13 (VV+)
    Always
    Below 1 Ω
    F78-14 (VV-) - P1-14 (VV-)
    Always
    Below 1 Ω
    F78-16 (ADPG) - P1-8 (ADPG)
    Always
    Below 1 Ω
    F78-6 (VV+) - Body ground
    Always
    10 kΩ or higher
    F78-14 (VV-) - Body ground
    Always
    10 kΩ or higher
    F78-13 (SG) - Body ground
    Always
    10 kΩ or higher
    F78-16 (ADPG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Visual Mute Signal Circuit between Radio Receiver and Television Display (from Jan 2012)Television Display Power Source Circuit (Sep 2011 – Dec 2011) →