2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Visual Mute Signal Circuit between Radio Receiver and Television Display

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This is the visual mute signal circuit from the multi-media module receiver assembly to the television display assembly.

WIRING DIAGRAM

E248573E01

INSPECTION PROCEDURE


1. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY

  1. E248569E01
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F78-4 (VMTR) - Body ground
    RSE is playing → Source is changed
    4 V or higher → Below 0.7 V → 4 V or higher

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Module Receiver Assembly)



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEVISION DISPLAY)
  1. Disconnect the F78 multi-media module receiver assembly connector.

  1. Disconnect the L53 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F78-4 (VMTR) - L53-17 (VMTR)
    Always
    Below 1 Ω
    F78-4 (VMTR) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY
  1. Disconnect the L53 television display assembly connector.

  1. E245657E02
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L53-17 (VMTR) - Body ground
    Display is operating
    4 V or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Television Display Assembly)



NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK

REPLACE TELEVISION DISPLAY ASSEMBLY (Click here)


← Visual Mute Signal Circuit between Navigation ECU and Television Display (Sep 2011 – Dec 2011)Display Signal Circuit between Radio Receiver and Video Terminal (from Jan 2012) →