2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Navigation ECU and Multi-media Interface ECU

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

The multi-media interface ECU sends a sound signal to the display and navigation module display through this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, radio receiver assembly, display and navigation module display or speakers.

WIRING DIAGRAM

E189784E08

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION MODULE DISPLAY - INTERFACE ECU)
  1. Disconnect the F61 display and navigation module display connector and L41 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F61-1 (AGND) - L41-1 (USD1)
    Always
    Below 1 Ω
    F61-3 (VAR+) - L41-2 (URO+)
    Always
    Below 1 Ω
    F61-4 (VAL+) - L41-3 (ULO+)
    Always
    Below 1 Ω
    F61-7 (VA-) - L41-4 (UGD1)
    Always
    Below 1 Ω
    F61-1 (AGND) - Body ground
    Always
    10 kΩ or higher
    F61-3 (VAR+) - Body ground
    Always
    10 kΩ or higher
    F61-4 (VAL+) - Body ground
    Always
    10 kΩ or higher
    F61-7 (VA-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier (from Jan 2012)Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Sep 2011 – Dec 2011) →