Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The multi-media module receiver assembly sends the sound signal to the stereo component amplifier assembly through this circuit.The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, multi-media module receiver assembly or speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the F84 multi-media module receiver assembly connector.
Disconnect the F85 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F84-1 (WUO) - F85-8 (WUI)
Always
Below 1 Ω
F84-2 (MI+) - F85-5 (MO+)
Always
Below 1 Ω
F84-3 (MI-) - F85-6 (MO-)
Always
Below 1 Ω
F84-4 (SLDI) - F85-7 (SLDO)
Always
Below 1 Ω
F84-5 (MO+) - F85-2 (MI+)
Always
Below 1 Ω
F84-6 (MO-) - F85-3 (MI-)
Always
Below 1 Ω
F84-7 (SLDO) - F85-4 (SLDI)
Always
Below 1 Ω
F84-1 (WUO) - Body ground
Always
10 kΩ or higher
F84-2 (MI+) - Body ground
Always
10 kΩ or higher
F84-3 (MI-) - Body ground
Always
10 kΩ or higher
F84-4 (SLDI) - Body ground
Always
10 kΩ or higher
F84-5 (MO+) - Body ground
Always
10 kΩ or higher
F84-6 (MO-) - Body ground
Always
10 kΩ or higher
F84-7 (SLDO) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
