2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT DPF SWITCH ASSEMBLY

  1. A271314
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 4
    Switch OFF
    10 kΩ or higher
    1 - 4
    Switch ON
    Below 1 Ω

    If the result is not as specified, replace the DPF switch assembly.

  1. Apply battery voltage to the switch connector and check that the DPF switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Apply battery voltage to terminal 3 (+) and 2 (-)
    Mark illumination illuminates

    If the result is not as specified, replace the DPF switch assembly.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →