2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A178998
    Remove the 2 nuts and V-bank cover.


4. DISCONNECT NO. 2 FUEL HOSE

  1. A176296E02
    Detach the fuel hose clamp.

  1. Detach the lock claw by lifting up the cover, as shown in the illustration.

  1. Pinch and pull the No. 2 fuel hose connector to disconnect the connector from the No. 3 fuel pipe.

    NOTICE:
    1. Check for foreign matter in the pipe and around the connector. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the pipe and connector.
    2. Do not use any tools to separate the pipe and connector.
    3. Do not forcefully bend or twist the nylon tube.
    4. Check for foreign matter on the pipe seal surface. Clean if necessary.
    5. Put the pipe and connector ends in plastic bags to prevent damage and foreign matter contamination.
    6. If the pipe and connector are stuck together, pinch the connector between your fingers and turn it carefully to disconnect it.


5. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY

  1. A176413E01
    Disconnect the fuel injector connector.

  1. Remove the pulsation damper, upper gasket, fuel hose and lower gasket.

    NOTICE:
    1. Put a cloth or equivalent under the delivery pipe.
    2. Slowly loosen the pulsation damper.

← COMPONENTS (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →