DATA LIST / ACTIVE TEST
System information · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| DATA LIST |
- HINT:
- Using the intelligent tester to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Data List.
According to the display on the intelligent tester, read the Data List.
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ACC SW
Ignition switch / ACC or OFF
ON: Ignition switch ACC
OFF: Ignition switch off
"ON" is also displayed for this item when the ignition switch is ON.
IG SW
Ignition switch / ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch is ACC.
Stop Light SW
Stop light switch / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
D Door Courtesy SW
Front door courtesy light switch LH signal / ON or OFF
ON: Front door courtesy light switch LH on
OFF: Front door courtesy light switch LH off
-
P Door Courtesy SW
Front door courtesy light switch RH signal / ON or OFF
ON: Front door courtesy light switch RH on
OFF: Front door courtesy light switch RH off
-
RR Door Courtesy SW
Rear door courtesy light switch RH signal / ON or OFF
ON: Rear door courtesy light switch RH on
OFF: Rear door courtesy light switch RH off
-
RL Door Courtesy SW
Rear door courtesy light switch LH signal / ON or OFF
ON: Rear door courtesy light switch LH on
OFF: Rear door courtesy light switch LH off
-
Back Door Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door courtesy light switch on
OFF: Back door courtesy light switch off
-
Dimmer SW
Dimmer switch signal / ON or OFF
ON: Dimmer switch on
OFF: Dimmer switch off
-
Passing Light SW
Passing light switch signal / ON or OFF
ON: Passing light switch on
OFF: Passing light switch off
-
Front Fog Light SW*1
Front fog light switch signal / ON or OFF
ON: Front fog light switch on
OFF: Front fog light switch off
-
Auto Light SW*2
Auto light switch signal / ON or OFF
ON: Auto light switch on
OFF: Auto light switch off
-
Head Light SW (Head)
Headlight switch signal / ON or OFF
ON: Headlight switch (Head) on
OFF: Headlight switch (Head) off
-
Head Light SW (Tail)
Taillight switch signal / ON or OFF
ON: Headlight switch (Tail) on
OFF: Headlight switch (Tail) on
-
Illumination Rate lnfo
Illumination rate / min.: 0, max.: 99.99
Actual illumination rate displayed
-
I/L ON W/Door Key Unlock
Interior light ON with unlock / ON or OFF
Customize setting displayed.
-
Lighting Time
Lighting Time / 7.5s or 15s or 30s
Customize setting displayed.
-
I/L when ACC OFF
I/L ON/ACC OFF Light the I/L when ACC OFF / ON or OFF
Customize setting displayed.
-
Light Control
Light control / ON or OFF
ON: Light control system on
OFF: Light control system off
-
Sensitivity
Turn on luminous intensity / DARK1, DARK2, NORMAL, LIGHT1, LIGHT2
Customize setting displayed.
-
Disp Ex ON Sen
Display extinction luminous intensity / DARK1, DARK2, NORMAL, LIGHT1, LIGHT2
Customize setting displayed.
-
Disp Ex OFF Sen
Display extinction release luminous intensity / DARK1, DARK2, NORMAL, LIGHT1, LIGHT2
Customize setting displayed.
-
- *1: w/ Front Fog Light
- *2: w/ Automatic Light Control System
HL Auto Leveling (w/ Static Headlight Auto Leveling) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Headlight Low Beam State
Low beam headlight state / ON or OFF
ON: Low beam headlights on
OFF: Low beam headlights off
-
+B
Ignition power supply voltage value / 0 to 19.75 V
11 to 14 V
-
Height Sens Pw Supply Val
Rear height control sensor power supply value / 0 to 5 V
4.7 to 5.2 V
-
Rr Height Sens Signal Val
Rear height control sensor signal value / 0 to 5 V
Approximately 2.5 V (When vehicle level)
The value changes according to the vehicle height.
Vehicle Speed
Vehicle speed / 0 to 327.67 km/h
Actual vehicle speed
-
Rear Height Adjust Valid Flag
Result of rear vehicle height calibration / Valid or Inval
Valid: Rear vehicle height calibration completed
Inval: Rear vehicle height calibration not completed
-
Init Writing Count
Number of times initialization performed / 0 to 255
Current condition displayed
-
Sensor Initialization Hist
Sensor initialization history / not comp, 10%, 25%, 50%, 75%, 100% or complied
Current condition displayed
-
Number Of Trouble Codes
Number of trouble codes / 0 to 255
Condition can be displayed
-
AFS (w/ Dynamic Headlight Auto Leveling) Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Headlight Low Beam State
Low beam headlight state / ON or OFF
ON: Low beam headlights on
OFF: Low beam headlights off
-
Headlight High Beam State
High beam headlight state / ON or OFF
ON: High beam headlights on
OFF: High beam headlights off
-
Engine
Engine condition / Run or Stop
Run: Engine running
Stop: Engine stopped
-
+B
Ignition power supply voltage value / 0 to 19.75 V
11 to 14 V
-
Height Sens Pw Supply Val
Height control sensor power supply value / 0 to 6.25 V
4.7 to 5.2 V
-
Fr Height Sens Signal Val*
Front height control sensor signal value / 0 to 5 V
Approximately 2.5 V (When vehicle level)
The value changes according to the vehicle height.
Rr Height Sens Signal Val
Rear height control sensor signal value / 0 to 5 V
Approximately 2.5 V (When vehicle level)
The value changes according to the vehicle height.
FR Wheel Speed
Front right wheel speed / 0 to 327.67 km/h
Condition can be displayed
-
FL Wheel Speed
Front left wheel speed / 0 to 327.67 km/h
Condition can be displayed
-
Vehicle Speed
Vehicle speed / 0 to 327.67 km/h
Condition can be displayed
-
Rear Height Adjust Valid Flag
Rear height adjustment range / Valid or Inval
Condition can be displayed
-
Init Writing Count
Number of times for initialization / 0 to 255
Condition can be displayed
-
Sensor Initialization Hist
Sensor initialization history / not comp, 10%, 25%, 50%, 75%, 100% or complied
Condition can be displayed
-
Number Of Trouble Codes
Number of trouble codes / 0 to 255
Condition can be displayed
-
- *: w/ Active Height Control Suspension
- *1: w/ Front Fog Light
| ACTIVE TEST |
- HINT:
- Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the Ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / (desired system) / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Main Body Tester Display
Test Part
Control Range
Diagnostic Note
Hazard
Hazard warning signal
ON/OFF
-
Illuminated Entry System
Illumination light
ON/OFF
-
Indicator for Lighting
Illumination of switch indicator operation
ON/OFF
-
Taillight Relay
Taillight
ON/OFF
-
Headlight Relay
Headlight
ON/OFF
-
Head Light Hi
Headlight (Hi)
ON/OFF
-
Front Fog Light Relay*1
Front fog light
ON/OFF
-
Rear Fog Light Relay*2
Rear fog light
ON/OFF
-
Dimmer Signal
Illumination dimming operation
ON/OFF
-
- *1: w/ Front Fog Light
- *2: w/ Rear Fog Light
HL Auto Leveling (w/ Static Headlight Auto Leveling) Tester Display
Test Part
Control Range
Diagnostic Note
Drive The Leveling Motor UP*
Headlight leveling motor upward operation
ON/OFF
ON: Move up
OFF: Stop
Drive The Leveling Motor DOWN*
Headlight leveling motor downward operation
ON/OFF
ON: Move down
OFF: Stop
- *: Perform the Active Test with the engine running and vehicle stopped.
AFS (w/ Dynamic Headlight Auto Leveling) Tester Display
Test Part
Control Range
Diagnostic Note
Drive The Leveling Motor UP*
Headlight leveling motor upward operation
ON/OFF
ON: Move up
OFF: Stop
Drive The Leveling Motor DOWN*
Headlight leveling motor downward operation
ON/OFF
ON: Move down
OFF: Stop
AFS OFF Indicator
Headlight beam level control system warning light
ON/OFF
-
- *: Perform the Active Test with the engine running and vehicle stopped.
- *1: w/ Front Fog Light