B1244 Light Sensor Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Sep 2011
DESCRIPTION
This DTC is stored when a failure of the automatic light control sensor circuit is detected.| DTC Code |
DTC Detection Condition |
Trouble Area |
| B1244 |
When either condition below is met:
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK FOR DTC |
Clear the DTC (Click here).
Recheck for DTC (Click here).
- OK:
- DTC B1244 is not output.
|
|
||||
| OK | ||
| ||
| 2. READ VALUE USING INTELLIGENT TESTER (AUTOMATIC LIGHT CONTROL SENSOR) |
Operate the intelligent tester according to the display and select "Data List".
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Illumination Rate Info
Illumination rate/min.: 0, max.: 99.99
Actual illumination rate is displayed
-
- OK:
- Output illuminance is as shown in table above.
|
|
||||
| OK | ||
| ||
| 3. CHECK MAIN BODY ECU (LIGHT CONTROL SENSOR VOLTAGE) |
Measure the voltage according to the value(s) in the table below.

- Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
E2-20 (CLTB) - E2-18 (CLTE)
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR) |
![]() ![]() |
Disconnect the E2 ECU connector.
Disconnect the F9 sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E2-20 (CLTB) - F9-6 (CLTB)
Always
Below 1 Ω
E2-19 (CLTS) - F9-5 (CLTS)
E2-18 (CLTE) - F9-3 (CLTE)
E2-20 (CLTB) - Body ground
Always
10 kΩ or higher
E2-19 (CLTS) - Body ground
E2-18 (CLTE) - Body ground
|
|
||||
| OK | ||
| ||

