2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT SEAT HEATER SWITCH

B181863E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (RV) - 6 (SW)
    3 (RV) - 4 (SW)
    Switch off
    2.7 to 4.1 kΩ
    Switch on (Min)
    Switch on (Max)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the seat heater switch.

  1. Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 8 (ILL+)
    Battery negative (-) → 5 (ILL-)
    Illuminates

    If the result is not as specified, replace the seat heater switch.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →