2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPLACEMENT

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REPLACE STUD BOLT

NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.

  1. Remove the stud bolts.

  1. Install new stud bolts.

    Torque:
    for stud bolt A and B:
    11 N*m{ 112 kgf*cm , 8 ft.*lbf }
    for stud bolt C:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }


    A134758E03


2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion Height:
    Item
    Specified Condition
    Pin "A"
    22.5 to 23.5 mm (0.889 to 0.925 in.)
    Pin "B"
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin "C"
    8.5 to 9.5 mm (0.335 to 0.374 in.)
    Pin "D"
    5.5 to 6.5 mm (0.217 to 0.256 in.)


    A174376E01


3. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTICE:
If water leaks from the tight plug or the plug corrodes, replace it.

  1. Remove the tight plugs.

  1. A132063E01
    Apply adhesive around new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using SST and a hammer, tap in the tight plugs to the standard depth.

    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07150)

    Standard depth:
    0.2 to 1.2 mm (0.00787 to 0.0472 in.)


    A076064E09


4. REPLACE OIL JET

NOTICE:
It is not necessary to remove the oil jet unless it is being replaced.

  1. Using a screwdriver and hammer, tap out the oil jet.

  1. A076392E05
    Using a screwdriver and hammer, tap in a new oil jet as shown in the illustration.


5. REPLACE CONNECTING ROD SMALL END BUSH

  1. EM06363E01
    Using SST and a press, press out the bush.
    SST
    09222-30010  

  1. A051812E01
    Align the oil holes of a new bush and the connecting rod.

  1. EM06363E01
    Using SST and a press, press in the bush.
    SST
    09222-30010  

  1. EM06535E01
    Using a pin hole grinder, hone the bush to obtain the standard oil clearance between the bush and piston pin.

    Standard oil clearance:
    0.005 to 0.011 mm (0.000197 to 0.000433 in.)

    HINT:
    Check that the piston pin fits at a normal room temperature. Coat the piston pin with engine oil, and push it into the connecting rod with a thumb.

← INSPECTION (from Jan 2012)REPLACEMENT (from Jan 2012) →