2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPLACEMENT

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove a straight pin unless it is being replaced.


A224781E03
Text in Illustration 
*a
Front Side
*b
Rear Side
*c
Upper Side
*d
Lower Side
  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion Height:
    Item
    Specified Condition
    Pin A
    22.5 to 23.5 mm (0.886 to 0.925 in.)
    Pin B
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin C
    8.5 to 9.5 mm (0.335 to 0.374 in.)
    Pin D
    5.5 to 6.5 mm (0.217 to 0.256 in.)


2. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTICE:
If coolant leaks from a tight plug or a plug is corroded, replace it.


A221129E03
Text in Illustration 
*1
Standard Depth
-
-
*a
LH Side
*b
RH Side
  1. Remove the tight plugs.

  1. Apply adhesive around new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using SST and a hammer, tap in the tight plugs to the standard depth.

    SST
    09950-60010   (09951-00350)
    09950-70010   (09951-07150)

    Standard depth:
    0.2 to 1.2 mm (0.00787 to 0.0472 in.)

← REPLACEMENT (Sep 2011 – Dec 2011)REASSEMBLY (Sep 2011 – Dec 2011) →