2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011


1. REPLACE STUD BOLT

HINT:
If a stud bolt is deformed or the threads are damaged, replace it.

  1. Using an E7 "TORX" wrench, replace the stud bolts labeled A shown in the illustration below.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Using an E8 "TORX" wrench, replace the stud bolts labeled B shown in the illustration below.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


    A164621E01


2. REPLACE STRAIGHT PIN

NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.

  1. Remove the straight pins.

  1. Using a plastic-faced hammer, tap in new straight pins to the cylinder block.

    Standard Protrusion:
    Item
    Specified Condition
    Pin "A" and "B"
    5.0 to 7.5 mm (0.197 to 0.295 in.)
    Pin "C"
    10.5 to 11.5 mm (0.413 to 0.453 in.)
    Pin "D" and "F"
    3.5 to 6.0 mm (0.138 to 0.236 in.)
    Pin "E"
    4.5 to 7.0 mm (0.177 to 0.276 in.)


    A164620E03


3. REPLACE CYLINDER BLOCK TIGHT PLUG

NOTICE:
If water leaks from the tight plug or the plug corrodes, replace it.

  1. Remove the tight plugs.

  1. A132063E02
    Apply adhesive around new tight plugs.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Using SST and a hammer, tap in the tight plugs to the specified depth.

    SST
    09950-60010   (09951-00180, 09951-00250, 09951-00350)
    09950-70010   (09951-07150)

    Standard depth:
    1.7 to 2.7 mm (0.0669 to 0.106 in.)


    A164619E02


4. REPLACE CRANKSHAFT STRAIGHT PIN

A158685

NOTICE:
It is not necessary to remove the crankshaft straight pin unless it is being replaced.

  1. Replace the pin.

← INSPECTION (from Sep 2011)REASSEMBLY (from Sep 2011) →