2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P060D Internal Control Module Accelerator Pedal Position Performance

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

The ECM monitors the input signals of the accelerator pedal position sensor No. 1. When the input signals and control signals deviate, a DTC is stored.
DTC No.
DTC Detection Condition
Trouble Area
P060D
Either condition is met (1 trip detection logic):
  1. There is an ECM main CPU error.
  2. There is an ECM sub CPU error.
ECM

CONFIRMATION DRIVING PATTERN

  1. Turn the engine switch off.
  2. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
  3. Connect the cable to the negative (-) battery terminal.
  4. Turn the engine switch on (IG) and wait for 16 seconds or more.

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the GTS on.

  1. Clear DTCs (Click here).

  1. Turn the GTS off.

  1. Turn the engine switch off.

  1. Disconnect the GTS.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Connect the GTS to the DLC3.

  1. Turn the engine switch on (IG) and turn the GTS on.

  1. Wait 16 seconds or more.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Check for DTCs.

    OK:
    P060D is not output.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← P060B Internal Control Module A/D Processing Performance (from Jan 2012)P060E Internal Control Module Throttle Position Performance (from Jan 2012) →