HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use these procedures to troubleshoot the windshield deicer system.
- *: Use the intelligent tester.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| NEXT |
|
 |
|
|
| 2.INSPECT BATTERY VOLTAGE |
- Standard Voltage:
- 11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| NEXT |
|
 |
|
|
Check the vehicle type.
Result
Result
|
Proceed to
|
w/o Multi-display
|
A
|
w/ Multi-display
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 4.CHECK LIN COMMUNICATION SYSTEM |
Check if the LIN communication system is functioning normally (Click here).
- OK:
- LIN DTC is not output.
|
NG.
|
 |
|
|
| OK |
|
 |
|
|
| 5.CHECK CAN COMMUNICATION SYSTEM |
Check if the CAN communication system is functioning normally.
- OK:
- CAN DTC is not output.
Result
Result
|
Proceed to
|
CAN DTC is not output
|
A
|
CAN DTC is output (for LHD)
|
B
|
CAN DTC is output (for RHD)
|
C
|
Refer to the Problem Symptoms Table (Click here).
Result
Result
|
Proceed to
|
Fault is not listed in problem symptoms table
|
A
|
Fault is listed in problem symptoms table
|
B
|
|
B.
|
 |
|
|
| A |
|
 |
|
|
| 7.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|
| NEXT |
|
 |
|
|