2011-2013 Land Cruiser · Service Manual Vehicle Exterior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use these procedures to troubleshoot the window defogger system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK VEHICLE TYPE
    1. Check the vehicle type.

      Result 
      Result
      Proceed to
      w/o Navigation System
      A
      w/ Navigation System
      B


    B.
    A

    4.CHECK LIN COMMUNICATION SYSTEM
    1. Check if the LIN communication system is functioning normally (Click here).

      Result 
      Result
      Proceed to
      LIN DTC is output.
      A
      LIN DTC is not output.
      B


    B.
    A

    5.CHECK CAN COMMUNICATION SYSTEM
    1. Check if the CAN communication system is functioning normally.

      1. for LHD: Click here
      2. for RHD: Click here
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD)
      B
      CAN DTC is output (for RHD)
      C


    B.

    C.
    OK

    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    NEXT

    8.REPAIR OR REPLACE
      NEXT

      9.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Sep 2011 – Dec 2011)PROBLEM SYMPTOMS TABLE (Sep 2011 – Dec 2011) →