2011-2013 Land Cruiser · Service Manual Vehicle Exterior

TERMINALS OF ECU

System information · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (w/ Rear Heater)
B189780E01
  1. Disconnect the E36 air conditioning amplifier assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E36-5 (IG+) - E36-1 (GND)
    G - W-B
    Power source (IG)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    E36-6 (+B1) - E36-1 (GND)
    R - W-B
    Power source
    Always
    11 to 14 V
    E36-7 (+B2) - E36-1 (GND)
    R - W-B
    Power source
    Always
    11 to 14 V
    E36-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E36 air conditioning amplifier assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E36-24 (RDEF) - E36-1 (GND)
    G - W-B
    Defogger relay
    Ignition switch ON and defogger switch off
    11 to 14 V
    Ignition switch ON and defogger switch on
    Below 1 V


CHECK AIR CONDITIONING AMPLIFIER (w/o Rear Heater)
B160781E03
  1. Disconnect the E81 air conditioning amplifier assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E81-1 (IG+) - E81-14 (GND)
    G - W-B
    Power source (IG)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    E81-21 (+B1) - E81-14 (GND)
    R - W-B
    Power source
    Always
    11 to 14 V
    E81-14 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the E81 air conditioning amplifier assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    E81-38 (RDEF) - E81-14 (GND)
    G - W-B
    Defogger relay
    Ignition switch ON and defogger switch off
    11 to 14 V
    Ignition switch ON and defogger switch on
    Below 1 V


CHECK AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
B185502E01
  1. Disconnect the F10 air conditioning control assembly connector.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    F10-7 (IG+) - F10-1 (GND)
    G - W-B
    Power source (IG)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    F10-1 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1. If the result is not as specified, there may be a malfunction on the wire harness side.


MULTI-MEDIA MODULE RECEIVER ASSEMBLY (w/ Navigation System)
E238995E08
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
F77-17 (+B1) - F77-12 (GND1)
R - W-B
Power source
Always
11 to 14 V
F77-12 (GND1) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
F77-15 (IG) - F77-12 (GND1)
G - W-B
Power source (IG)
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
F77-16 (ACC1) - F77-12 (GND1)
GR - W-B
Power source (ACC)
Ignition switch ACC
11 to 14 V
Ignition switch off
Below 1 V
F77-35 (UIND)
R
UART communication signal
-
-
F77-36 (UPSW)
P
UART communication signal
-
-
F77-1 (CANH)
P
CAN communication signal
-
-
F77-2 (CANL)
B
CAN communication signal
-
-

MULTI-DISPLAY ASSEMBLY (w/ Navigation System)
E237781E16
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
F79-12 (+B2) - F79-13 (GND1)
R - BR
Power source
Always
11 to 14 V
F79-13 (GND1) - Body ground
BR - Body ground
Ground
Always
Below 1 Ω
F79-23 (IG) - F79-13 (GND1)
G - BR
Power source (IG)
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
F79-24 (ACC) - F79-13 (GND1)
GR - BR
Power source (ACC)
Ignition switch ACC
11 to 14 V
Ignition switch off
Below 1 V
F79-3 (UPSW)
P
UART communication signal
-
-
F79-4 (UIND)
R
UART communication signal
-
-
← TERMINALS OF ECU (Sep 2011 – Dec 2011)DATA LIST / ACTIVE TEST (from Sep 2011) →