2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RH and LH.
  2. The procedures listed below are the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  1. B180820
    Detach the clip and claw, and remove the front door lower frame bracket garnish LH.


3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

  1. B180816E01
    Using a screwdriver, detach the 4 claws and remove the front door inside handle bezel LH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


4. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

  1. B182892
    Remove the 3 screws and master switch.


5. REMOVE ASSIST GRIP COVER LH

  1. B180819
    Using a moulding remover, detach the 8 claws and remove the door assist grip cover LH.


6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B310800E01
    Remove the 3 screws.

  1. Remove the 13 clips.

  1. Remove the front inner door glass weatherstrip LH together with the front door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

    HINT:
    Make sure that the pin labeled A in the illustration is detached from the door panel.

  1. Disconnect the connector.

  1. B180822
    Disconnect the 2 cables from the front door inside handle sub-assembly LH.


7. REMOVE SIDE AIRBAG SENSOR

  1. B181765
    Disconnect the connector.

  1. Remove the bolt and side airbag sensor.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →