2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE INTAKE VALVE

  1. A050250E02
    Using SST, compress the compression spring and remove the 2 valve spring retainer locks.
    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

  1. Remove the spring retainer, inner compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


2. REMOVE EXHAUST VALVE

  1. A050249E01
    Using SST, compress the compression spring and remove the 2 valve spring retainer locks.
    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

  1. Remove the spring retainer, inner compression spring and valve.

    HINT:
    Arrange the removed parts in the correct order.


3. REMOVE VALVE STEM OIL SEAL

  1. A050489E02
    Using needle nose pliers, remove the stem oil seals.


4. REMOVE VALVE SPRING SEAT

  1. A123801
    Using compressed air and a magnetic finger, remove the valve spring seat by blowing air onto it.


5. REMOVE NO. 1 STRAIGHT SCREW PLUG

  1. A168573
    Using a 14 mm hexagon wrench, remove the screw plugs and gasket.


6. REMOVE STUD BOLT

NOTICE:
If the stud bolt is deformed or its threads are damaged, replace it.

← COMPONENTS (Sep 2011 – Dec 2011)INSPECTION (Sep 2011 – Dec 2011) →