INSPECTION
Inspection · Vehicles built from Sep 2011
| INSPECT FRONT NO. 1 SUSPENSION ARM LOWER SUB-ASSEMBLY LH |
![]() ![]() |
As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.
Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the fifth turn.
- Standard turning torque:
- 0.2 to 10.0 N*m (2.0 to 102 kgf*cm, 1.8 to 89 in.*lbf)
Check for any cracks and grease leaks on the ball joint dust cover.


