Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011from Jan 2012
DESCRIPTION
The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN). If there is a problem in this intercommunication, the ECM stores a DTC.
DTC Code
DTC Detection Condition
Trouble Area
U0100
No communication with the ECM continues.
ECM
INSPECTION PROCEDURE
1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0100)
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the tester.
Result
Result
Proceed to
Only U0100 is output
A
U0100 and other DTCs are output
B
HINT:
If any other codes besides U0100 are output, perform troubleshooting for those DTCs first.