2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

U0101 Lost Communication with TCM

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN). If there is a problem in this intercommunication, the ECM stores a DTC.
DTC Code
DTC Detection Condition
Trouble Area
U0101
No communication with the ECM continues.
ECM

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT (IN ADDITION TO DTC P0101)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the engine switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / ECT / Trouble Codes.

  1. Read the DTCs using the tester.

    Result 
    Result
    Proceed to
    Only U0101 is output
    A
    U0101 and other DTCs are output
    B

    HINT:
    If any other codes besides U0101 are output, perform troubleshooting for those DTCs first.



B
GO TO DTC CHART (Click here)
A


2. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


3. CHECK IF DTC RECURS
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Read the DTCs using the tester.

    Result 
    Result
    Proceed to
    No DTC output
    A
    Other DTCs output
    B



B
GO TO DTC CHART (Click here)
A

END


← P2226 Barometric Pressure Circuit (+ P2228, P2229) (from Jan 2012)U0101 Lost Communication with TCM (from Jan 2012) →