2011-2013 Land Cruiser · Service Manual Drivetrain

REPLACEMENT

Removal / installation · Vehicles built from Sep 2011


1. DRAIN TRANSFER OIL

  1. C173746
    except 1GR-FE:
    Remove the 2 bolts and transfer dynamic damper.

  1. C171487
    Remove the 4 bolts and transfer heat insulator.

  1. C173748
    Remove the 7 bolts and lower transfer case protector.

  1. C172047
    Remove the filler plug and gasket.

  1. C172046
    Remove the drain plug and gasket, and drain the transfer oil.


2. ADD TRANSFER OIL

  1. C172046
    Install a new gasket onto the drain plug and then install the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. C083746E08
    Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

    NOTICE:
    1. Add oil slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. C172047
    Install a new gasket onto the filler plug and then install the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. C173748
    Install the lower transfer case protector with the 7 bolts.

    Torque:
    14 N*m{ 139 kgf*cm , 10 ft.*lbf }

  1. C171487
    Install the transfer heat insulator with the 4 bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }

  1. C173746
    except 1GR-FE:
    Install the transfer dynamic damper with the 2 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

← ON-VEHICLE INSPECTION (from Sep 2011)COMPONENTS (from Sep 2011) →