2011-2013 Land Cruiser · Service Manual Drivetrain

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK TRANSFER OIL

  1. C172047
    Remove the filler plug and gasket.

  1. C083746E08
    Check that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
    If the result is not as specified, add transfer oil.

    Viscosity:
    SAE 75W

    Standard Capacity:
    1.4 to 1.5 liters (1.5 to 1.6 US qts, 1.2 to 1.3 Imp. qts)

    NOTICE:
    Too much or too little oil will lead to transfer problems.

  1. When the oil level is too low, check for oil leaks.

  1. C172047
    Install a new gasket onto the filler plug and then tighten the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


ADD TRANSFER OIL

  1. C172047
    Remove the filler plug and gasket.

  1. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.

    NOTICE:
    1. Add oil slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. C172047
    Install a new gasket onto the filler plug and then tighten the plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

← INSPECTION (from Jan 2012)REPLACEMENT (from Sep 2011) →