2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built Sep 2011 – Dec 2011


INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Power Steering Pressure.

    5. Start the engine.

    6. Operate the steering wheel while idling, and read the value on the intelligent tester.

      Standard:
      Condition
      Specified Condition
      Power steering not operating
      0 to 2 MPa
      Power steering operating
      Values change from above value

      If not as specified, check for DTCs (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.
      Inspect the power steering system (Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

← COMPONENTS (Sep 2011 – Dec 2011)REMOVAL (Sep 2011 – Dec 2011) →