2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A178461
    Remove the 10 bolts and No. 1 engine under cover.


4. REMOVE V-BANK COVER SUB-ASSEMBLY

  1. A178998
    Remove the 2 nuts and V-bank cover.


5. REMOVE AIR CLEANER HOSE ASSEMBLY

  1. A175163
    Disconnect the vacuum transmitting hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.


6. REMOVE FAN & GENERATOR V BELT

  1. B000809E02
    Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.


7. DRAIN POWER STEERING FLUID

8. REMOVE POWER STEERING OIL PRESSURE SWITCH

  1. A175755E01
    Disconnect the sensor connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.

  1. Remove the O-ring.

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →