2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine / Data List / Primary / Power Steering Signal.

    5. Start the engine.

    6. Operate the steering wheel while idling, and read the value on the intelligent tester.

      OK:
      Condition
      Specified Condition
      Power steering operation
      ON
      Power steering not operation
      OFF

      If not as specified, check for DTCs (w/o DPF: Click here, w/DPF: Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.
      Inspect the power steering system (w/o DPF: Click here, w/DPF: Click here). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)REMOVAL (Sep 2011 – Dec 2011) →