2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Sep 2011


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 7 clips and upper radiator support seal.


2. REMOVE FRONT FENDER MAIN SEAL LH

  1. B181061
    Using a clip remover, detach the 3 clips and remove the fender main seal.


3. REMOVE FRONT FENDER MAIN SEAL RH

HINT:
Use the same procedures described for the LH side.


4. REMOVE FRONT WIPER ARM LH
  1. Remove the nut, wiper arm and blade.


5. REMOVE FRONT WIPER ARM RH
  1. Remove the nut, wiper arm and blade.


6. REMOVE HOOD TO COWL TOP SEAL

  1. E156189
    Using a clip remover, detach the 12 clips, 4 clamps and remove the hood to cowl top seal.


7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

  1. E156188
    Remove the washer hose.

  1. E156191
    Remove the 2 clips.

  1. Detach the 17 claws and remove the cowl top ventilator louver sub-assembly.


8. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A174701
    Remove the 2 nuts and No. 1 engine cover.


9. REMOVE INTERCOOLER ASSEMBLY

  1. A174703
    Loosen the No. 1 air hose clamp.

  1. A174702
    Loosen the No. 2 air hose clamp.

  1. A174704
    Disconnect the turbo pressure sensor connector, intake air temperature sensor connector and vacuum hose.

  1. A174705
    Remove the 6 nuts, 2 bolts and intercooler.

  1. Remove the 2 gaskets from the air tube LH and RH.


10. REMOVE ENGINE COVER BRACKET

  1. A174726
    Remove the 2 bolts and engine cover bracket.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →