2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL VVT SENSOR
  1. Install the 4 VVT sensors with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the 4 VVT sensor connectors.


2. INSTALL CAMSHAFT POSITION SENSOR
  1. Install the camshaft position sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the camshaft position sensor connector.


3. INSTALL AIR CLEANER CAP AND HOSE
  1. Install the air cleaner cap and hose, and then tighten the hose clamp.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }

  1. Attach the 4 clamps.

  1. Connect the mass air flow meter connector and attach the clamp.

  1. Connect the No. 2 PCV hose and No. 1 air hose.


4. INSTALL V-BANK COVER SUB-ASSEMBLY

  1. A274416E01
    Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.
    Text in Illustration 
    *1
    Grommet
    *2
    Pin
    *3
    Hook
    *4
    Bracket

← REMOVAL (from Jan 2012)COMPONENTS (from Jan 2012) →