2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT ENGINE OIL LEVEL SENSOR
  1. Heat the switch to higher than 60°C (140°F) in an oil bath.

  1. A164340E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON at 20°C (68°F)
    Below 1 Ω
    OFF at 20°C (68°F)
    Below 1 Ω
    ON at 60°C (140°F)
    Below 1 Ω
    OFF at 60°C (140°F)
    10 kΩ or higher

    If the result is not as specified, replace the engine oil level sensor.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →