2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE WINCH MOTOR ASSEMBLY

  1. B180487
    Remove the 4 bolts and member.

  1. B180488
    Remove the 8 bolts and winch base.

  1. B167951
    Remove the 3 bolts and winch motor.


2. REMOVE NO. 2 WINCH EARTH WIRE

  1. B188298
    Remove the bolt and winch earth wire.


3. REMOVE WINCH ROLLER BRACKET ASSEMBLY

  1. B188407
    Remove the 2 nuts, 4 bolts and winch roller bracket.


4. REMOVE MAGNET SWITCH WINCH COVER

  1. B180508
    Remove the 4 screws and cover.


5. REMOVE WINCH MOTOR MAGNET SWITCH ASSEMBLY

  1. B180509
    Disconnect the connector.

  1. Remove the 2 nuts, 2 spring washers, 2 washers and wire harness.

  1. B180510
    Remove the 4 bolts and magnet switch from the motor.


6. REMOVE WINCH MOTOR COMMUTATOR END FRAME

  1. B180512
    Remove the 2 bolts and commutator end frame.


7. REMOVE WINCH MOTOR O-RING
  1. Remove the O-ring.


8. REMOVE WINCH MOTOR BRUSH

  1. B180513
    Using a screwdriver, pry the bush spring forward and pull the brush out of the holder.

  1. B180514
    Remove the bolt and brush from the brush holder.

    HINT:
    Use the same procedures to remove the 3 remaining brushes.


9. REMOVE WINCH MOTOR BRUSH HOLDER ASSEMBLY

  1. B184478
    Remove the brush holder in the direction of the arrow shown in the illustration.


10. REMOVE WINCH MOTOR YOKE SUB-ASSEMBLY

  1. B184477
    Remove the yoke in the direction of the arrow shown in the illustration.


11. REMOVE WINCH MOTOR ARMATURE SUB-ASSEMBLY

  1. B180528
    Remove the armature in the direction of the arrow shown in the illustration.


12. REMOVE NO. 1 WINCH MOTOR ARMATURE BEARING

  1. B180525E01
    Using SST, remove the bearing.
    SST
    09286-46011  


13. REMOVE NO. 2 WINCH MOTOR ARMATURE BEARING

  1. B180526E01
    Using SST, remove the bearing.
    SST
    09628-62011  


14. REMOVE WINCH MOTOR BRUSH SPRING

  1. B184770E01
    Insert a screwdriver, labeled A, as shown in the illustration and pry the spring forward, then move the spring in the direction of the arrow shown in the illustration with a screwdriver, labeled B, to remove it from the holder.

← REMOVAL (from Jan 2012)INSPECTION (from Sep 2011) →