2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT OVERHEAT TEMPERATURE INDICATOR

B167945E01
  1. Apply battery voltage and check operation of the remote control switch, as shown in the table below.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal B
    Battery negative (-) → Terminal E
    Overheat temperature indicator light illuminates and buzzer sounds

    If the result is not as specified, replace the remote control switch assembly.


INSPECT REMOTE CONTROL SWITCH CIRCUIT

B168131E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A - B*1
    B - C
    B - E*2
    Not pushed
    Below 1 Ω
    B - D
    Pushed to IN
    Below 1 Ω
    B - F
    Pushed to OUT
    Below 1 Ω

    HINT:
    1. *1: Connect the positive (+) lead of the ohmmeter to terminal B and the negative (-) lead to terminal A.
    2. *2: Connect the positive (+) lead of the ohmmeter to terminal E and the negative (-) lead to terminal B.

    If the result is not as specified, replace the remote control switch assembly.

← ON-VEHICLE INSPECTION (from Jan 2012)COMPONENTS (from Sep 2011) →