2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. REMOVE STARTER CLUTCH PINION

A163092
  1. Using snap ring pliers, remove the snap ring.

    HINT:
    While pushing down the starter clutch pinion, remove the snap ring.

  1. Remove the pinion stop collar, starter clutch pinion and starter drive spring.


2. REMOVE STARTER BRUSH HOLDER ASSEMBLY

  1. A175299
    Remove the 2 starter hoses from the starter.

  1. A175300E01
    Remove the nut from terminal C.

  1. Remove the 2 through bolts and 2 screws, then remove the commutator end frame from the starter yoke.

  1. A163085
    Using a screwdriver, hold the starter brush spring back and disconnect the 4 starter brushes from the brush holder.

  1. Remove the starter brush holder from the starter armature.


3. REMOVE STARTER YOKE ASSEMBLY

  1. A163086
    Remove the starter yoke.

  1. A163097
    Remove the 2 O-rings from the starter yoke.


4. REMOVE STARTER ARMATURE ASSEMBLY

  1. A175301
    Remove the starter armature from the starter plate.


5. REMOVE STARTER INTERNAL GEAR

  1. A175302
    Remove the starter plate.

  1. A175303
    Remove the starter washer.

  1. A175304
    Remove the 3 starter planetary gears.

  1. A175305
    Remove the starter internal gear.


6. REMOVE STARTER DRIVE HOUSING ASSEMBLY

  1. A175306
    Remove the 2 bolts and starter drive housing from the magnet starter switch.


7. REMOVE STARTER CLUTCH SUB-ASSEMBLY

  1. A163094
    Using snap ring pliers, remove the snap ring.

  1. Remove the pinion drive lever and 3 washers.

  1. Remove the starter clutch from the magnet starter switch.

← REMOVAL (from Jan 2012)INSPECTION (from Sep 2011) →