REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
| 1.
REMOVE OIL FILLER CAP SUB-ASSEMBLY |
|
| 2.
REMOVE NO. 2 ENGINE UNDER COVER
|
 |
Remove the 6 bolts and under cover.
| 3.
DRAIN ENGINE OIL
|
 |
- Remove the oil drain plug and gasket, and drain the engine oil into a container.
| 4.
REMOVE ENGINE OIL LEVEL SENSOR |
 |
- Disconnect the oil level sensor connector.
Remove the 4 bolts and oil level sensor.
- Cut off the gasket as shown in the illustration.
Remove the gasket from the oil level sensor.
- HINT:
- After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.