2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2012

HINT:
  1. Use the following procedure to troubleshoot the parking assist monitor system (w/ Side Monitor System).
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage with the engine switch off.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

    NEXT

    3.CHECK NAVIGATION SYSTEM
    1. Refer to the navigation system (Click here).

      Result 
      Result
      Proceed to
      Navigation system is normal
      A
      Navigation system is abnormal
      B


    B.
    A

    4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      1. for LHD: Click here
      2. for RHD: Click here
      Result 
      Result
      Proceed to
      CAN DTC is not output
      A
      CAN DTC is output (for LHD)
      B
      CAN DTC is output (for RHD)
      C


    B.

    C.
    A

    5.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Clear the DTC (Click here).

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      NOTICE:
      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the parking assist monitor system (w/ Side Monitor System) are output, refer to Diagnostic Trouble Code Chart for the applicable system.
      System
      Proceed to
      Side Monitor System
      Click here
      Wide View Front Monitor System
      Click here

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    B.
    A

    6.PROBLEM SYMPTOMS TABLE
    1. Refer to the Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B


    B.
    A

    7.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Data List / Active Test (Click here).

    2. Terminals of ECU (Click here).

    NEXT

    8.ADJUST, REPAIR OR REPLACE
      NEXT

      9.CONFIRMATION TEST
        NEXT

        ← SYSTEM DESCRIPTION (from Jan 2012)INITIALIZATION (from Jan 2012) →