2011-2013 Land Cruiser · Service Manual Brake

C1417 High Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (master cylinder solenoid) stores this DTC and the fail-safe function prohibits ABS/VSC/TRC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.
This DTC is cleared when the IG1 terminal voltage returns to normal.
DTC Code
DTC Detection Condition
Trouble Area
C1417
The IG1 terminal voltage is 17.4 V or higher for 0.8 seconds or more.
  1. Charging system
  2. Power source circuit
  3. Internal power supply circuit of the skid control ECU (master cylinder solenoid)

WIRING DIAGRAM

Refer to DTC C1241 (Click here).

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).


1. CHECK HARNESS AND CONNECTOR (IG1 TERMINAL)
  1. Disconnect the skid control ECU (master cylinder solenoid) connector.

  1. C214161E73
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A24-46 (IG1) - Body ground
    Ignition switch ON
    (Engine running)
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU [Master Cylinder Solenoid])
    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1VD-FTV)
    B
    NG (for 1UR-FE)
    C
    NG (for 3UR-FE)
    D



B
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)

C
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)

D
GO TO CHARGING SYSTEM (ON-VEHICLE INSPECTION) (Click here)
A


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)


← C1415 Rear Speed Sensor RH Output Malfunction (+ C1277, C1278, C1416) (from Jan 2012)C1419 Acceleration Sensor Internal Circuit (+ C1435) (from Jan 2012) →