2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

The No. 1 clearance warning buzzer sounds to alert the driver and the buzzed frequency changes depending on the distance to an obstacle.

WIRING DIAGRAM

E246939E01
E246939E02

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (NO. 1 CLEARANCE WARNING BUZZER)
  1. Select the Active Test, use the intelligent tester to generate a control command, and then check that the buzzer operates (Click here).

    Clearance Sonar 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Buzzer
    No. 1 clearance warning buzzer
    Operate or Stop
    -

    OK:
    No. 1 clearance warning buzzer sounds.

    Result 
    Result
    Proceed to
    OK
    A
    NG (w/ Side Monitor System)
    B
    NG (w/o Side Monitor System)
    C



B
Go to step 2

C
Go to step 3
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

2. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - NO. 1 CLEARANCE WARNING BUZZER)
  1. Disconnect the F75 parking assist ECU connector.

  1. Disconnect the E10 No. 1 clearance warning buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F75-7 (BBZ) - E10-1 (Z+)
    Always
    Below 1 Ω
    F75-6 (EF) - E10-2 (Z-)
    Always
    Below 1 Ω
    F75-7 (BBZ) - Body ground
    Always
    10 kΩ or higher
    F75-6 (EF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NO. 1 CLEARANCE WARNING BUZZER (Click here)

3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - NO. 1 CLEARANCE WARNING BUZZER)
  1. Disconnect the F12 clearance warning ECU connector.

  1. Disconnect the E10 No. 1 clearance warning buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F12-10 (BBZ) - E10-1 (Z+)
    Always
    Below 1 Ω
    F12-11 (EF) - E10-2 (Z-)
    Always
    Below 1 Ω
    F12-10 (BBZ) - Body ground
    Always
    10 kΩ or higher
    F12-11 (EF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NO. 1 CLEARANCE WARNING BUZZER (Click here)


← Clearance Warning Buzzer Circuit (Sep 2011 – Dec 2011)Clearance Warning ECU Power Source Circuit (Sep 2011 – Dec 2011) →