2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Clearance Warning ECU Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU.

WIRING DIAGRAM

E137255E08

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG NO. 1)
  1. Remove the ECU-IG NO. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG NO. 1 fuse
    Always
    Below 1Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND)
E153349E02
  1. Disconnect the F12 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F12-15 (IG) - Body ground
    Engine switch on (IG)
    11 to 14 V
    F12-15 (IG) - Body ground
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F12-17 (GND1) - Body ground
    Always
    Below 1Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (from Jan 2012)Clearance Warning ECU Power Source Circuit (from Jan 2012) →