2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT UPPER CENTER BUMPER RETAINER

B180999
  1. Install the bumper retainer with the 3 bolts.


2. INSTALL HEADLIGHT ASSEMBLY LH
  1. for Standard:
    Install the headlight assembly LH (Click here).

  1. for HID Headlight:
    Install the headlight assembly LH (Click here).


3. INSTALL HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. INSTALL FRONT BUMPER SIDE SUPPORT LH

B180998
  1. Attach the 3 clips to install the side support.

  1. Install the 2 screws.


5. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.


6. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH

B181000
  1. Install the bumper extension with the 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }


7. INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


8. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

B180997
  1. Install the reinforcement with the 6 nuts.

    Torque:
    71 N*m{ 724 kgf*cm , 52 ft.*lbf }


9. INSTALL FRONT BUMPER ENERGY ABSORBER

B180996
  1. Install the energy absorber.


10. INSTALL FRONT BUMPER COVER

B181927

HINT:
For the front bumper cover with garnish, use the procedures described below.

  1. w/ Headlight Cleaner System:
    Connect the headlight cleaner hose.

  1. w/o TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Attach the 10 claws to install the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
    Connect the No. 4 engine room wire connector and attach the 10 claws to install the bumper cover.

  1. Install the 3 clips, 4 screws and 4 bolts.

    B180995

  1. Using a T30 "TORX" socket, install the 6 screws.

    B180994E01


11. INSTALL RADIATOR GRILLE ASSEMBLY

B180899
  1. Attach the 2 clips and 8 claws to install the radiator grille.

  1. Install the 3 screws.


12. INSTALL UPPER RADIATOR SUPPORT SEAL

  1. Install the radiator support seal with the 7 clips.

    B180890E02


13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Push in the clip indicated by the arrow in the illustration to install the fender splash shield.

  1. Install the 3 bolts and screw.


14. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← REASSEMBLY (from Jan 2012)INSTALLATION (from Jan 2012) →