2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

B180991
  1. Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the fender splash shield.


3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. Remove the 7 clips and radiator support seal.

    B180890E02


5. REMOVE FRONT BUMPER WINCH COVER SUB-ASSEMBLY

6. REMOVE RADIATOR GRILLE ASSEMBLY

B180899E01
  1. Put protective tape around the radiator grille.

  1. Remove the 3 screws.

  1. Detach the 2 clips and 8 claws, and remove the radiator grille.


7. REMOVE FRONT BUMPER COVER

  1. Put protective tape around the bumper cover.

    B185485E01

  1. Using a T30 "TORX" socket, remove the 6 screws.

    B180994E01

  1. Remove the 3 clips, 4 screws and 4 bolts.

  1. Detach the 10 claws.

  1. w/o TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Disconnect the winch control wire connector and remove the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
    Disconnect the No. 4 engine room wire connector and winch control wire connector and remove the bumper cover.

    B185486


8. REMOVE FRONT BUMPER EXTENSION LH

B185487
  1. Remove the 3 bolts and bumper extension.


9. REMOVE FRONT BUMPER EXTENSION RH

HINT:
Use the same procedures described for the LH side.


10. REMOVE FRONT BUMPER SIDE SUPPORT LH

B180998
  1. Remove the 2 screws.

  1. Detach the 3 clips and remove the side support.


11. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.


12. REMOVE HEADLIGHT ASSEMBLY LH
  1. for Standard:
    Remove the headlight assembly LH (Click here).

  1. for HID Headlight:
    Remove the headlight assembly LH (Click here).


13. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


14. REMOVE FRONT UPPER CENTER BUMPER RETAINER

B185488
  1. Remove the 3 bolts and bumper retainer.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →