DISASSEMBLY
Removal / installation · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
REMOVE NO. 4 ENGINE ROOM WIRE (w/ Fog Light) |
 |
Disconnect the 2 connectors.
Detach the 11 clamps and remove the No. 4 engine room wire.


| 2.
REMOVE FRONT BUMPER INNER BRACKET (w/ Fog Light) |
 |
- Detach the 3 claws and remove the front bumper inner bracket.
| 3.
REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
|
 |
- Remove the 2 screws.
Text in Illustration
 
|
Screw
|
 
|
Connector
|
Detach the 2 guides and remove the fog light assembly LH.
Disconnect the connector.
| 4.
REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light) |
 |
- HINT:
- Use the same procedure described for the LH side.
| 5.
REMOVE FRONT BUMPER HOLE COVER LH (w/ Fog Light) |
 |
- Remove the 2 retainers and the 2 screws.
- Detach the 5 claws and remove the front bumper hole cover LH.
| 6.
REMOVE FRONT BUMPER HOLE COVER RH (w/ Fog Light) |
 |
- HINT:
- Use the same procedure described for the LH side.
| 7.
REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light) |
 |
- Remove the 2 retainers and the screw.
- Detach the 5 claws and remove the front bumper hole cover LH.
| 8.
REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light) |
 |
- HINT:
- Use the same procedure described for the LH side.
| 9.
REMOVE LOWER RADIATOR GRILLE LH |
 |
- Detach the 6 claws and remove the lower radiator grille LH.
| 10.
REMOVE LOWER RADIATOR GRILLE RH |
 |
- HINT:
- Use the same procedure described for the LH side.
| 11.
REMOVE FRONT NO. 2 BUMPER PROTECTOR |
 |
- Remove the 2 front No. 2 bumper protectors.
| 12.
REMOVE FRONT LICENSE PLATE BRACKET (w/ Bracket) |
 |
- Remove the 2 nuts and front license plate bracket.
| 13.
REMOVE WINCH CONTROL WIRE
|
 |
- Remove the 2 nuts and winch control wire.