2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

B190217
  1. Install the protector with 2 new grommets.

  1. Install the 2 screws.


2. INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

HINT:
Use the same procedures described for the LH side.


3. INSTALL REAR BUMPER ARM BRACKET LH

B181013
  1. Install the bumper arm bracket with the 2 bolts.

  1. Connect the connector.


4. INSTALL REAR BUMPER ARM BRACKET

B181012

HINT:
Use the same procedure to install the bumper arm bracket on the other side.

  1. Install the bumper arm bracket with the bolt.


5. INSTALL REAR NO. 2 BUMPER REINFORCEMENT

B181019
  1. Install the bumper reinforcement with the 2 bolts.


6. INSTALL REAR BUMPER SIDE SUPPORT LH

B181014
  1. Attach the 6 claws to install the bumper side support.

  1. Install the 3 screws.


7. INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedures described for the LH side.


8. INSTALL UPPER REAR BUMPER RETAINER LH

B181015
  1. Attach the 2 clips to install the bumper retainer.


9. INSTALL UPPER REAR BUMPER RETAINER RH

HINT:
Use the same procedures described for the LH side.


10. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

  1. E155847
    Connect the connector.

  1. Attach the 2 clips to install the rear combination light.

  1. Install the 2 bolts.


11. INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


12. INSTALL REAR BUMPER COVER
  1. w/o TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Attach the 14 claws to install the bumper cover.

  1. w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
    Connect the No. 2 frame wire connector and attach the 14 claws to install the bumper cover.

  1. Install the 7 bolts, 6 screws and 2 clips.

    B181009

  1. Open the tail gate and install the 4 clips.

    B181011

  1. Close the tail gate.


13. INSTALL REAR NO. 1 BUMPER PLATE

  1. Attach the 20 claws to install the bumper plate.

    B181008


14. INSTALL REAR QUARTER PANEL MUDGUARD LH

B180882
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 6 screws.


15. INSTALL REAR QUARTER PANEL MUDGUARD RH

B180883
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 7 screws.

← REASSEMBLY (from Jan 2012)INSTALLATION (from Jan 2012) →