2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
  1. Install the No. 2 luggage compartment side cover protector with 2 new grommets.

  1. Install the 2 screws.


2. INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

HINT:
Use the same procedure described for the LH side.


3. INSTALL REAR BUMPER ARM BRACKET LH
  1. Install the rear bumper arm bracket LH with the 2 bolts.

  1. Connect the connector.


4. INSTALL REAR BUMPER ARM BRACKET
  1. Install the rear bumper arm bracket with the bolt.

    HINT:
    Use the same procedure to install the rear bumper arm bracket on the other side.


5. INSTALL REAR NO. 2 BUMPER REINFORCEMENT
  1. Install the rear No. 2 bumper reinforcement with the 2 bolts.


6. INSTALL REAR BUMPER SIDE SUPPORT LH
  1. Attach the 6 claws to install the rear bumper side support LH.

  1. Install the 3 screws.


7. INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure described for the LH side.


8. INSTALL REAR UPPER BUMPER RETAINER LH
  1. Attach the 2 clips to install the rear upper bumper retainer LH.


9. INSTALL REAR UPPER BUMPER RETAINER RH

HINT:
Use the same procedure described for the LH side.


10. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Attach the 2 clips to install the rear combination light assembly LH.

  1. Install the 2 bolts.

  1. Attach the 6 claws and install the 2 covers.


11. INSTALL REAR COMBINATION LIGHT ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


12. INSTALL REAR BUMPER COVER
  1. w/ TOYOTA Parking Assist-sensor System:
    Connect the No. 2 frame wire connector.

  1. Attach the 14 claws to install the rear bumper cover.

  1. Install the 7 bolts, 6 screws and 2 clips.

  1. Open the tail gate and install the 4 clips.

  1. Close the tail gate.


13. INSTALL REAR NO. 1 BUMPER PLATE
  1. Attach the 20 claws to install the rear No. 1 bumper plate.


14. INSTALL REAR QUARTER PANEL MUDGUARD LH

B180882
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 6 screws.


15. INSTALL REAR QUARTER PANEL MUDGUARD RH

B180883
  1. Install the mudguard with the clip.

  1. Using a T30 "TORX" socket, install the 7 screws.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (Sep 2011 – Dec 2011) →