Detach the 2 claws and remove the No. 1 ultrasonic sensor.
HINT:
Use the same procedure for all No. 1 ultrasonic sensors.
The illustration shows the No. 1 ultrasonic sensor for the RH corner and back sensor LH and RH. The installation position of the No. 1 ultrasonic sensor for the LH corner is on the opposite side.
Detach the 2 claws and remove the No. 1 ultrasonic sensor retainer from the rear bumper cover.
HINT:
Use the same procedure to remove the No. 1 ultrasonic sensor retainer on the other side.
The illustration shows the No. 1 ultrasonic sensor retainer for the RH corner. The vertical orientation of the No. 1 ultrasonic sensor retainers for the LH corner is opposite that of the image shown in the illustration.